EnthuZ
12-11-2002, 02:13 AM
Most, if not all Zs have a pin on the front rotor/hub to prevent the rear wheels from being mounted on the front. These MUST be removed to install aftermarket wheels. All it is , is a bolt about 3/4 inch in length(I'm not a metric kinda guy:o ), holding a sleeve/tube of about 1/2 inch length.
To remove, use a 12 mm wrench or socket, and turn normally counterclockwise. I just "popped" the handle with my palm, and it came loose. No need to use the old hammer handle between the studs trick, which will prevent the rotor from turning.......:D
Without further adooooooo, the pics:
To remove, use a 12 mm wrench or socket, and turn normally counterclockwise. I just "popped" the handle with my palm, and it came loose. No need to use the old hammer handle between the studs trick, which will prevent the rotor from turning.......:D
Without further adooooooo, the pics: